BizTalk 2006 R2 SP1 alters the disassembling behaviour of a Receive pipeline !

By patrickwellink
March 19, 2010
Comments Off on BizTalk 2006 R2 SP1 alters the disassembling behaviour of a Receive pipeline !

In my previous post I mentioned i noticed a change in the disassembling behaviour of BizTalk Server 2006 R2 after installing SP 1.

After I got home after work I sat down and looked somewhere on my harddisk for an old version of  a BizTalk 2006 Virtual PC. After a while I found one that was approximately  one and a half year untouched. So I sat down and Fired it up…

First get all the updates that have been since then, geeeeeez there have been many, I had about 80 of them and i completely forgot that some of them took ages to install (Visual Studio SP / Several Dotnet’s etc). Whel about two hours later i could test my scenario.

I created a solution and I copied (used cut & paste) the envelope and body from the previous post to this solution. Add a strong key, deploy and I was off to test.

With the pre SP1 BizTalk 2006 R2 (On Windows Server 2003 R2) I got the results I expected.

So i copied the entire VPC to a new location and added the extension SP1 to the machine name to distinguish it from the other. Then i downloaded and installed Service pack 1 for BizTalk 2006 R2.

After a reboot I was good to go….

To my dissapointment i got the same result as on work. Below is a

Event Type: Error
Event Source: BizTalk Server 2006
Event Category: BizTalk Server 2006
Event ID: 5719
Date:  3/19/2010
Time:  10:42:38 PM
User:  N/A
Computer: TITANNIC
There was a failure executing the receive pipeline: “Microsoft.BizTalk.DefaultPipelines.XMLReceive, Microsoft.BizTalk.DefaultPipelines, Version=, Culture=neutral, PublicKeyToken=31bf3856ad364e35” Source: “Pipeline ” Receive Port: “Batched Receive” URI: “C:ProjectsService Pack TestService Pack TestTestInput*.xml” Reason: The disassembler found an envelope that does not have the body element.

For more information, see Help and Support Center at

So i can definitelye say : SP1 for BizTalk 2006 R2 alters the default disassembling behaviour ! ( And in my case broke my solution)

For everybody who wants to test, I have added a very small solution to demonstrate what goes wrong…..

Comments: 0

Comments are closed.

  • Recent Posts
  • Recent Comments
  • Archives
  • Categories
  • Meta